[SystemSafety] Fault, Failure and Reliability Again (short)
Mike Ellims
michael.ellims at tesco.net
Wed Mar 4 16:58:22 CET 2015
Some time back I had the opportunity to sit down with the heads of the FAA
certification panel (we were doing something unusual) and we discussed this
to a great extent. The outcome is that for the purposes of certification the
failure rate of software is not considered as the FAA do not believe it
possible to reliably calculate a failure rate for software.
The figure of 10^(-9) applies ONLY to hardware; software is required to meet
the process/quality requirements as given in DO-178 and verified means of
audit (i.e. they come in and work you over ;-).
Cheers.
-----Original Message-----
From: systemsafety-bounces at lists.techfak.uni-bielefeld.de
[mailto:systemsafety-bounces at lists.techfak.uni-bielefeld.de] On Behalf Of
Peter Bernard Ladkin
Sent: 04 March 2015 14:55
To: systemsafety at lists.techfak.uni-bielefeld.de
Subject: Re: [SystemSafety] Fault, Failure and Reliability Again (short)
On 2015-03-04 15:22 , Peter Bernard Ladkin wrote:
> I didn't say "standards", I said certification requirements.
I take that back. I in fact said "certification standards". What I meant
was, US 14 CFR 25.1309(b) :
[begin quote]
(b) The airplane systems and associated components, considered separately
and in relation to other systems, must be designed so that-
(1) The occurrence of any failure condition which would prevent the
continued safe flight and landing of the airplane is extremely improbable,
and
(2) The occurrence of any other failure conditions which would reduce the
capability of the airplane or the ability of the crew to cope with adverse
operating conditions is improbable.
[end quote]
and CS-25.1309(b) :
[begin quote]
(b) The aeroplane systems and associated components, considered separately
and in relation to other systems, must be designed so that -
(1) Any catastrophic failure condition
(i) is extremely improbable; and
(ii) does not result from a single failure; and
(2) Any hazardous failure condition is extremely remote; and
(3) Any major failure condition is remote.
[end quote]
Suppose you have a piece of kit whose behavior can result in a failure
condition (which would prevent..../ catastrophic), and this kit is digital
and its behavior is largely governed by SW logic.
Here's a fault tree / causal failure graph / BBN:
<kit fails catastropically> <--- ((HW fails in such-and-such a way) OR (SW
fails in such-and-such a
way))
The regs set a numerical condition on the left-hand node: namely, extremely
improbable, which is to say a probability of 10^(-9) per operating hour
(used not to mean it, but does now). You've got to get that from equivalent
sorts of measures on the RHS.
I take it people are content with doing it for the LH disjunct: HW fails at
(less than) probability X per operating hour.
So, now who's going to tell me you don't need to do it for the RH disjunct?
PBL
Prof. Peter Bernard Ladkin, Faculty of Technology, University of Bielefeld,
33594 Bielefeld, Germany Je suis Charlie
Tel+msg +49 (0)521 880 7319 www.rvs.uni-bielefeld.de
_______________________________________________
The System Safety Mailing List
systemsafety at TechFak.Uni-Bielefeld.DE
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
More information about the systemsafety
mailing list